Back to top

2008 Sundance B18CCR

Havelock, North Carolina

This boat has all brand new cushions, the motor has just been serviced and we also added new control cables. This boat is ready to go! Contact us today!

 

The B Series Boats have a 94 inch beam width. The B18CCR is our newest model and has a yacht finish front and rear deck connected with a gunwale ring cap. The ring cap gives the boat top sides a much more finished look and allows us to use a larger and stiffer rub rail. We also use the best 316 grade stainless steel cleats and fitting on these models. The ring cap also gives us a space to install rod holders under the coming rail for additional rod and gaff storage. The front deck still has the cushioned jump seats built into it with additional storage below. This boat has the CC console without a front seat as standard equipment and has our custom built triple rod racks mounted on both sides of the console. The console is set up for a top mount binnacle control. A 33 gallon fuel tank is located inside the console with a fuel fill located on the port side of the console. The instrument panel has a fuel gauge, voltmeter and a tachometer with a digital hour meter. A space is provided for a two inch engine monitor gauge. There is a Marinco stainless steel power point in the face of the dash for supplemental power for cell phones and hand held GPS instruments. A four switch electrical panel with circuit breaker overload protection and Johnson aerator pumps and automatic bilge pumps are standard. We have added wire conduits glassed into the floor at the hull edge for ease in pulling wires forward for trolling motors and other electrical equipment. A standard feature is a trolling wire harness and receptacle set using Ancor marine grade 8AWG tinned wire layed into the port side conduit for the trolling motor. The steering wheel is a 15 inch stainless steel wheel coupled to a Uflex no-feed-back helm using the newest planetary gear helm system for solid smooth steering with no transmitted engine torque back to the wheel. The custom molded Lexan windshield and stainless steel console hand-rail are standard as well. The stern and bow light poles are stored in clips under the front deck. The long rear deck has an 40 quart aerated live well with a high speed pick-up. The high speed pick-up jets fresh water up to the bait well while the boat is in motion without the aerator pump running. The helm seat is a 76 quart insulated cooler with a seat cushion and has a swing-back back rest. - 2008 Sundance with a Yamaha F90

Basic Boat Info

Price: $9,100
Make: Sundance
Model: B18CCR
Year: 2008
Condition: Used
Category: Power
Construction: Fiberglass

Dimensions

Length: 17 ft
Beam: 7'10 ft
Max Draft: 0'6 ft
Dry Weight: 1,690 lb

Engines / Speed

Engines: 1
  • Make: Yamaha
  • Fuel: Unleaded
  • Engine Power: 90hp
  • Type: Outboard
  • Engine Hours: 258

Tanks

Fuel Tanks: 1
Fuel Tank Capacity: 39.6 gal

Other

Boat Class: Freshwater Fishing

Contact

BayRacer Marine Inc.

Office

BayRacer Marine Inc.
213 Hwy 70 West
Havelock, North Carolina, US, 28532
Tel:(252) 447-2277


Features
  • This boat has all new cushions
  • The motor has just been serviced
  • All new control cables!

This boat is ready to go! Contact us today!


$
%
$
Disclaimer This calculator is intended solely for general informational purposes, and to provide a rough estimate based on the information you provide. You should not base your decision on this estimate alone.